Menu
Bullyliner™ Coverage:
*Refer to the datasheet below for the application.
Note:
Depending on weather conditions, Bullyliner™’s standard full curing time is 72 hours from the application. longer full cure time can be expected in temperatures below 10℃. Bullyliner™ cross-linking chemical curing process is accelerated by UV light exposure. Please see the Bullyliner™ PDF user manual at the bottom of this page
1 Bullyliner™ Kit (4 x 1ltr Cans) Covers ∗Approx 260 SQFT. (24 Sqm) In One Coat. Minimum 2 Coats Are Recommended For Light To Moderate Abrasion Resistance. 3 Or More Coats Are Required For Commercial Use. Bullyliner™ Can Be Built To Any Thickness By Simply Applying Multiple Coats.
Bullyliner™ can be rolled, brushed or sprayed on. When applying Bullyliner, ensure temperatures are above 60F/15c. When spray applying, a minimum 8-gallon 150 PSI air compressor can be used for small projects, for larger projects requiring continuous air flow over longer time frames, a 20-gallon, 175 PSI air compressor is more suited, When using Bullyliner we recommenced using the Bullyliner spray gun. The best application air pressure for smooth even coverage is between 40-60 PSI.
Bullyliner™ MUST BE TOUCH DRY BETWEEN COATS. Depending on weather conditions, Bullyliner™ will touch dry in 30 minutes and re-coatable thereafter. Full curing time is approx 72 hours from application. longer full cure time can be expected in cooler temperatures. Bullyliner cross-linking chemical curing process is accelerated by UV light exposure. Depending on the durability required, Bullyliner can be built up as you like by applying multiple coats. All unused products should be stored with the lid sealed and kept away from direct sunlight ideally stored inside. Please see the Bullyliner™ PDF user manual and hints & Tips below.
All surfaces must be clean, lightly sand to scuff surface. any advanced rust should be treated with Nutech EcoSafe rust converter inhibitor.
After light sanding, wipe down all surfaces with acetone removing all dust to ensure the surface is prepared.
After light sanding, wipe down all surfaces with acetone removing all dust to ensure the surface is prepared.
Tape masking paper around all surrounding areas to avoid any over spray.
Apply first coat of Bully rubber liner evenly to entire surface.
Once the first coat is touch dry, before re-coating.
Apply 2nd coat of Bully Rubber liner evenly to enter surface.
If any repairs are needed, lightly sand affected area, re-apply Bully Rubber Liner by roller, brush or spray.
Bullyliner™ can be built up to any thickness simply by applying multiple coats. for commercial use a minimum of 3-4 coats may be required.